General Studies · Machine Design
Which of the following is NOT a typical advantage of using an interference fit in a shaft and hole assembly?
Verified Solution4 OptionsUpdated: October 2026👁️1 View
Share:
- 1Increased load-bearing capacity
- 2Prevention of relative motion between parts
- 3Ease of disassembly for maintenance✓
- 4Uniform stress distribution at the joint
Correct answer
Ease of disassembly for maintenance
Download Single Question PDF
Save this question and verified answer as a clean study sheet with live clickable link.
👥
Share with Friends & Study Groups
Challenge your peer aspirants on WhatsApp or Telegram to solve this question!
Online Test Series
Start Free Mock Test →Preparing for General Studies?
Practice full-length mock tests with real exam timers, instant score analysis, and all-India ranking.
Chapter Practice
Practice Machine Design MCQs →Want more practice questions on Machine Design?
Solve complete topic-wise tests with detailed solutions on GkGet.
Related Practice Questions
Recommended practice questions in General Studies · Machine Design