In a unpressurized gating system for sand-casting, to minimize turbulence and facilitate smooth flow of the molten metal, how should the cross-sectional areas of the sprue, runners, and gates be proportioned?

Question

Physics · Manufacturing Technology - Metal Casting

Verified Solution4 OptionsUpdated: October 2026👁️1 View

Share:

Correct answer

The cross-sectional area of the sprue choke should be smaller than that of the runners and gates

Save this question and verified answer as a clean study sheet with live clickable link.

👥

Challenge your peer aspirants on WhatsApp or Telegram to solve this question!

Online Test Series

Practice full-length mock tests with real exam timers, instant score analysis, and all-India ranking.

Chapter Practice

Want more practice questions on Manufacturing Technology - Metal Casting?

Solve complete topic-wise tests with detailed solutions on GkGet.

Recommended practice questions in Physics · Manufacturing Technology - Metal Casting

The arrival of which commission in India triggered widespread protests, including mass hartals across the country in 1928?

Which of the following leaders was instrumental in initiating and leading India’s struggle for independence?

Answer 1

The cross-sectional area of the sprue choke should be smaller than that of the runners and gates

Answer 2

The cross-sectional area of the sprue should be larger than that of the runners and gates

Answer 3

The cross-sectional area of the sprue, runners, and gates must all be equal

Answer 4

The cross-sectional area of the runners should be larger than the sprue and smaller than the gates

Related Practice Questions